CX-Y-level transmitter controller is set level measurement, display, output, the number of intelligent control in one of the significant level measurement and control products. The product is sealed for all-electronic structure can be achieved riot requirements, front-end using the magnetostrictive sensor to ensure the accuracy and long-term reliability, especially for a small range of low-density liquid level measurement. Selected high-performance CPU processing by the microprocessor computing scene, and output all the way analog and four-way switch, selectable RS-485 communication interface. 

 The liquid level transmitter controller using a flexible, simple to operate, easy to debug, safe and reliable. Widely used in water, electricity, water, oil, chemical, mechanical, hydraulic, and field measurements show that the level of media and control. 

 Features: 

 Installation: top thread wear, flange top-loading bypass side mounted 

 Using the magnetostrictive sensor resistance long-term stable and reliable, without periodic calibration 

 Especially suitable for the measurement of small-scale low-density level, independent of temperature with pressure on the environment. 

 4.4 LED digital display, ignore the error. 

 Four control points relay output AC220V/3A 

 6 4 ~ 20mA standard signal output 

 Control point of the scene is set. 

 Power supply Optional 24VDC AC220V 

 Technical parameters: 

 Range: 0-5000mm 

 Resolution: 0.3mm 

 Accuracy class: 1mm 

 Power supply voltage: AC220V; DC24V 

 Display: 0.56 "digital tube 

 Display range: -1999 to 9999 

 Ambient temperature: -20 ℃ ~ 70 ℃ 

 Relative Humidity: ≤ 80% 

 Installation: screw mounting (M52 * 1.5); 

 : Bypass side mounted flange mounting 

 Material: 304 stainless steel 

 Installation: 

 Mechanical connection: 

 CX-Y-level transmission controller can be made through the fittings bypass side mounted to the top of the thread (M52 * 1.5) installation or top flange mounting. 

 Electrical connection: 

 Terminal Figure 7-8 terminal is DC24V, 9,10 terminal AC220V power supply, two sets of power supply is not at the same time access. 

 In order to prevent the influence of electromagnetic interference should note the following: 

 ● connections as short as possible, the use of shielded cable 

 ● Try to avoid direct close to the junction of the user device may cause interference or electrical appliances and electronic devices 

 ● using a micro hose installation, the shell must be grounded separately. Order details: